MTX THUNDER SERIES Instrukcja Użytkownika Pobierz pdf (Strona 3)

MTX.COM

Parallel Conﬁ guration

T9922-44 – Wiring the voice coils in a parallel conﬁ guration will have a total ﬁ nal load of 2 Ohm. Connect each

of the dual voice coil’s positive terminals together so that they share the same source (ampliﬁ er). Do the same

for the negative terminals. This can be done with the included shorting bars. This connection is ideal when

using two Thunder TA92001 ampliﬁ ers.

T9922-22 – Wiring the voice coils in a parallel conﬁ guration will have a total ﬁ nal load of 1 Ohm. Connect each

of the dual voice coil’s positive terminals together so that they share the same source (ampliﬁ er). Do the same

for the negative terminals.

Note: The wiring of the dual voice coils will affect impedance for the ampliﬁ er system. Care must be taken

to assure that the resulting impedance does not exceed the ampliﬁ er’s requirements.

WIRING OPTIONS

Often overlooked, the installation components used to connect the entire system need to match the maximum

capability of the system or you will lose performance. MTX Audio recommends using StreetWires 4 AWG

cable as the speaker wire.

Dual Voice Coil Wiring

JackHammer Superwoofers are available in a dual 2 Ohm (T9922-22) or dual 4 Ohm (T9922-44) voice coil

conﬁ guration for either SPL or SQL uses. The voice coils are labeled VC1 and VC2.

Note: Both voice coils should always be connected. See the section on Strapping Thunder Ampliﬁ ers

for ampliﬁ er connections.

Independent Voice Coil Connection Conﬁ guration

This connection is ideal when using two Thunder TA81001 ampliﬁ ers per voice coil (4 ampliﬁ ers total).

You will need to remove the terminal shorting bars for this conﬁ guration. See the section on Strapping

Thunder Ampliﬁ ers for ampliﬁ er connections.

1 2 3 4 5 6 7

Brak uwag

MTX THUNDER SERIES Instrukcja Użytkownika Strona 3